Shape a vase.
A customizable 3D print by oddlyhelpful · Beta
Draw a vase.
Print it with no supports.
Drag its outline beside a center line and the vase turns round it, round, square or hexagonal. Rib the outside, cross the ribs into a lattice and twist them, or cut a pattern of holes through the wall, with a tube inside to hold the water. It downloads as an STL.
Beta. Two test vases have printed clean on an A1 mini so far. Print a short one before a tall one.
Shape a vase.
Replace every setting with the starting ones?
Loading the geometry kernel
The vase
Reads
Cut 0.6 mm into the underside of the base in letters 3 mm tall, as it reads with the vase turned over, which is the view here. The line is centered, and goes onto a second line if it is too long for one. In the middle, the line goes above the mark and a second line below it; with no room there, the mark moves to a corner.
Saved in this browser. Saving a loaded design again bumps its version.
Details
The selected one is what the Print step uses. Configure one to keep working on it.
Nothing saved yet. Shape your vase, name it, and save.
Downloads
Print it standing on its foot, in normal mode, with no supports.