Build a tissue box cover.
A customizable 3D print by oddlyhelpful · Beta
A tissue box cover,
sized to the box.
A cover that goes over a box of tissues from below. Start from one of the two boxes in a Costco pack of Kleenex, or type in your own. Pick the opening the tissues come out of, the outside, smooth, ribbed or a lattice, and how the base goes in: it slides along rails and clicks, or snaps in past lips. Both download as STLs, with a fit test to print first.
Beta. No cover has been printed yet. Print the fit test first: the cover's bottom edge, to try the base in.
Build a tissue box cover.
Replace every setting with the starting ones?
Loading the geometry kernel
The cover
Reads
Cut 0.6 mm into the underside of the base in letters 3 mm tall, as it reads with the cover turned over, which is the view here. The line is centered, and goes onto a second line if it is too long for one. In the middle, the line goes above the mark and a second line below it; with no room there, the mark moves to a corner.
Saved in this browser. Saving a loaded design again bumps its version.
Details
The selected one is what the Print step uses. Configure one to keep working on it.
Nothing saved yet. Build your cover, name it, and save.
Downloads
Print the cover upside down and the base flat, with no supports. Print the fit test first.